| BiTMICRO Knowledge Base |
|
fq040520-04 - Can the E-Disk® Support Single-Ended (SE) Signaling? 
QUESTION: If the E-Disk® 3S40 uses LVD signaling, can it support Single-Ended (SE) signaling? ANSWER: The E-Disk® 3S40 supports both LVD and SE signaling modes. The 3S40 attempts to operate in LVD mode upon power up but will switch to SE mode if another SE device is detected on the cable or if the cable does not support LVD transfers. RELATED DOWNLOAD(S):  User Manual: E-Disk 3S40D SCSI Wide Flash Drive
 Data Sheet: E-Disk® SCSI: 3.5" SCSI Wide Flash Disk
RELATED LINK(S): E-Disk® 3.5 SCSI Wide Flash Disk Product Page
Gary Field’s The Official SCSI FAQ: What is LVD (Low Voltage Differential)?
REFERENCE TO THIRD PARTIES AND THIRD PARTY WEB SITES There are links in this document that will allow you to connect to third-party websites over which BiTMICRO has no control. These links are provided for your convenience only and your use of them is at your own risk. BiTMICRO makes no representations whatsoever about the content of any of these websites. BiTMICRO does not endorse or accept any responsibility for the content, or use, of any such websites.
|